Page 1 of 1
Z32 AFM into VL?
Posted: Thu Dec 01, 2011 11:00 pm
by TUXEDO
Hi all. I've been trying to find a wiring diagram or specific instructions on how to wire a Z32 AFM into a VL with no success. Can anyone help Me out?
Cheers, Locky.
Re: Z32 AFM into VL?
Posted: Fri Dec 02, 2011 8:18 pm
by bachig24u
it's in the Nistune software user Manual.
a search on Z32 finds a few relevant pages. p36 has the wiring info you need.
Re: Z32 AFM into VL?
Posted: Fri Dec 02, 2011 9:54 pm
by TUXEDO
Well I have a Z32 plug only, no wires. So I need pin numbers and what size resistor? I've read something about installing a Zener diode somewhere too?
Re: Z32 AFM into VL?
Posted: Mon Dec 05, 2011 11:29 pm
by Matt
Type 1 hardware install manual for the mods (end of doc). I've removed zener diode part
Software Users Manual for the RB30 - Z32 AFM plug wiring required. I've found the resistor for calibration to be optional (ie tie to ground and then tune setup as this)
Re: Z32 AFM into VL?
Posted: Tue Dec 06, 2011 12:12 pm
by TUXEDO
Can someone link me to a diagram?
Re: Z32 AFM into VL?
Posted: Thu Dec 08, 2011 10:49 am
by TUXEDO
So I have found out which wires go to what pins on the Z32 plug and the mod to the ECU. Just need to know where to put the ~382 ohm resistor.
Re: Z32 AFM into VL?
Posted: Sat Dec 10, 2011 5:20 pm
by Matt
Red/yellow wire and ground (black)