Inj size change error and R33 GTR consult disconnect
Posted: Sat Mar 31, 2007 6:15 am
On a s13 sr20det today i experienced an error with the injector sizing function.
Starting with a standard blacktop map i changed to Z32 maf which worked fine.
I then went to change the injector size from stock to 550cc.
After entering the new injector size as 550 i applied the change and nistune then used 550 dec as the new k-value.
Null time was correct.
Also tried connecting to an R33 GTR standard ecu.
Using polled consult nistune made a connection, came up with the list of values to monitor, but disconnected immediately after clicking ok.
Usual checksum error/noise on line error message was displayed.
I experienced this same issue with an earlier version of nistune although i can't remember specifically which ecu it was with.
Either Z32 or or R33 GTS-t from memory.
Conzult connected without a problem indicating it wasn't a hardware related issue.
Starting with a standard blacktop map i changed to Z32 maf which worked fine.
I then went to change the injector size from stock to 550cc.
After entering the new injector size as 550 i applied the change and nistune then used 550 dec as the new k-value.
Null time was correct.
Also tried connecting to an R33 GTR standard ecu.
Using polled consult nistune made a connection, came up with the list of values to monitor, but disconnected immediately after clicking ok.
Usual checksum error/noise on line error message was displayed.
I experienced this same issue with an earlier version of nistune although i can't remember specifically which ecu it was with.
Either Z32 or or R33 GTS-t from memory.
Conzult connected without a problem indicating it wasn't a hardware related issue.