Noob ADR file question
Posted: Thu Aug 16, 2012 1:35 am
Hi all, I'm new here so apologies if this is in the wrong area or has been answered elsewhere ...
I recently had my type 1 ECR33 RB25DET tuned, and the tuner installed a type 2 nistune board into a z32 (41p03) ECU. Also installed 550cc injectors and z32 MAF at the same time.
Since then I have connected to the ECU to have a look around but wanted to make sure I am using the correct ADR file / values.
I'm using the z32 ADR file that matches the ECU part number, and have uploaded the mapped tables into Nistune directly from the ECU .. .but I want to know if I have to change the injector size value directly in the ADR file in order to read the already tuned map tables correctly? I wasn't sure if I changed the Injector size within Nistune whether it would change the already tuned values or not?
many thanks
I recently had my type 1 ECR33 RB25DET tuned, and the tuner installed a type 2 nistune board into a z32 (41p03) ECU. Also installed 550cc injectors and z32 MAF at the same time.
Since then I have connected to the ECU to have a look around but wanted to make sure I am using the correct ADR file / values.
I'm using the z32 ADR file that matches the ECU part number, and have uploaded the mapped tables into Nistune directly from the ECU .. .but I want to know if I have to change the injector size value directly in the ADR file in order to read the already tuned map tables correctly? I wasn't sure if I changed the Injector size within Nistune whether it would change the already tuned values or not?
many thanks