Page 1 of 1
Nats malfunction code
Posted: Thu Oct 11, 2012 3:57 am
by RaymondK
E3 dtc nats malfunction3 starts 0
Also getting flashing ecu check light on the dash,
I know I've have loads of faults but this is new and the
Trance thing is I had it running on Sunday?
Just went to start there to do timing map and no sir.
Cheers
Re: Nats malfunction code
Posted: Sat Oct 13, 2012 11:30 am
by Matt
I'm not sure on the exact cause of this issue but either the key code isnt working with the transponder, there is a connection error between transponder and ECU or they are mismatched for some reason?
Is it possible to get that checked by a Nissan dealer?
Re: Nats malfunction code
Posted: Mon Oct 15, 2012 4:34 am
by Eric
not sure if it's of any use, but the NATS E3 code stands for: open circuit in power source line of antenna/amp circuit.
Re: Nats malfunction code
Posted: Thu Nov 22, 2012 11:54 pm
by RaymondK
all fixed just cant get it started now... once its running its fine but its getting it started and then it wont idle on its own...
so im reckoning crank enrich/ fuelling/ timing/ idle graph is a miss somewhere...
thing is i cant get it to idle to get out the car then run it up and stick on the timing gun to see where it is etc etc.