Nistune Forums

Hi,
I have the following problem best explained by the screenshots:

When I connect to nistune I get this error:



when I click yes, this happens:



The ecu is Automatic UK S14 one with Nats2 system removed by installing jdm S14 firmware with the Base Image Programmer Board

I also have a question about the nistune's burn image button, if I use this, will the maps be permanently burned or can I still edit them?

You can still edit the maps, after burn and then burn again

You must have loaded a different address file previously. Nistune detected the correct one and has loaded it

but why is it totally blank?

No bin/image file is loaded?

When changing address files, the previous image is now cleaned out (if unsaved, you will be asked to save it first)

This is so that old vehicle data is not loaded when a different address file is used (I have seen tunes using a different vehicle base image with mismatched maps from syncing maps into the wrong vehicle base file)