HIGHLIGHTED FIELDS TYPE 4 BOARD

[UNISA JECS]

Hey Matt I attached a picture that says it all pretty much or if anyone else knows please share your knowledge, thanks

[UNISA JECS]

These are the actual fields highlighted at idle

[unex]

it means that these tables are accessed (in use) at that moment.

[Matt]

btw. These colour fields are documented in the user manual. Please reference for a full description

[UNISA JECS]

Hey Matt "Idle Timing Offset (warm)" deffinantly works while at warm idle but is not highlighted.

What it appears to do is "add" timing on top of what the timing map value is demanding

15degree targeted timing + 10degree "Idle Timing Offset (warm)" = ~25degree at idle only, once throttle is applied it revers back to the map demanded timing values.

[Matt]

Okay will look into it. Usually with the warm/cold tables means when the last crank was warm/cold. The temperature for this is 15 degC

So cold crank is < 15 degC and then the cold table is used, otherwise warm table is used. I'll double check to confirm. Yes the offset is conditionally added depending on TPS position

[Matt]

Check the temperature when you crank when connected to Nistune. If you connect after cranking Nistune cannot pick up which table and may highlight the wrong one

[UNISA JECS]

Hey Matt instead of making a new thread I'll just post what problems I found on my Type 4;

1) None of the tables are being highlighted at all

2) I noticed some tables are missing and I recall them working from previous versions of the past.

Attached is highlighted in the older version what's now missing in the newer version

[Matt]

Second screenshot does not show a log playback or consult connected?

First screen shot shows consult connected.

No green until you have active consult data

[UNISA JECS]

Second screenshot does not show a log playback or consult connected?

First screen shot shows consult connected.

No green until you have active consult data

That first screen shot was from along time ago and was quoted form this thread, the second screen shot was just screen captured from my desktop just for comparison purposes but while playing with my car last night I made a note that nothing was being highlighted while connected to consult and at the same time I also noticed that those two tables that I mentioned were missing.

but I think I can show you in real time via video screen capture that nothing is highlighted in the link below I have a video from last night

http://youtu.be/wjMC_rVJnu4?list=UU3Awy ... Dg-FTp1oaw

That video is also in a reply to another unrelated post about VE map tracing here viewtopic.php?f=5&t=2815&start=15

[Matt]

I'm away this week on limited data so cannot watch until next week