Nistune Forums

I have connected to the Aux1 of TE WBo2 2A0 unit a boost sensor, and i edited the aux1.csv files in order that the voltage be translated to mBar

the wideband window shows the value almost ok (there is a dot present afther the value but his presence is not bad), but on the fuel/ignition maps i could not see ok the value for the aux1

i have edited the file and switched from mBar to Bar, and i could see things write, but this problem need to be fixed especialy for the moment when EGT data display will be added (imagine displaying 1000C)
maybe the user should be able to chose betwen data shown as integer or float (real)



content of the aux1.csv file:
0000,-1000
0200,-800
1740,0
4900,1500

I can expand the field size on the grid view so you can see the whole number

With the large numbers, I can auto detect how many digits are being used and then use integer/float accordingly

With the AFR view I should be able to rescale the font size to the numbers fit on the screen

AFR is OK, i did not see any problem with it, i refer to the Aux1 (AFR was included in the red circle, in the attached picture, only because it is to close to aux1)