Nistune Forums

Type 1 board vers 3A
TE WBo2 2A0

before receiving the board i played for a while with the WBo2 unit and NIS tune, and teh only problem was that from time to time the conection with the WBo2 unit was lost.

today i have installed the Type 1 board into my CA18DET ecu, and it runs with no problem, loaded my moded bin, uploaded it saved the setings, played with idle rpm.....

then i wanted to connect to the WBo2 unit while i was also connected to the Type 1 board, and suprise afther a short time NIStune crashed.

i'll attach a movie, and 3 logs from when the software crashed

this sounds like the same problem I was having with the Zeitronix wideband if you remember matt?
maybe it can be fixed with logs that byreal can supply?

Yes I remember this. There is a CR open for this. Thanks for the logs. I can get onto that right away and reproduce the problem on the bench

Thanks for that

one more log, a special one

i opened nistune, conected to consult, and wideband unit, software crashed, i hided the crash by draging it alsomost out of the screen, reconeted to wideband or consult (i'm not remeber witch), afther a short time a new error abot memory reading apeared, hided also this error, and reconected to wideband or consult, and afther a short wile the software crashed with no error and it closed himself.

i have attached the log, for this "story" maybe more useful data can fe found in it.

hi matt, just so you are aware, i too am crashing when the wideband is open, latest version.

i'll connect it up and have a look into it tonight...

version xxx15
CA18DET + TE WBo2 2A0 and no crash