Page 1 of 1

NISTUNE disconnects on 1.2bar , 1bar is fine ... wth ?

Posted: Tue Apr 08, 2014 7:45 am
by IceManPL
Hi
Car: s14a.
Mods: Stock engine, gt2871, 300zx maf, 550cc injectors from subaru, 3" exhaust
Everything was fine at 0.5, 0.8, 1 bar (rare random disconnects, but not bad) and then at 1.2 bar nistune keeps disconnecting at 4000-4500 rpm.
Switching to stream mode give me a little more rpms, and disconnects at about 5000-5600 rpm.
Also closing map window, afr window and leaving only log window open helps a little - strange ...

I know the first answer, check the electrical ground ;) Seems ok ...

So what else to look for ?

Re: NISTUNE disconnects on 1.2bar , 1bar is fine ... wth ?

Posted: Tue Apr 08, 2014 11:31 am
by Matt
I've updated this document today:
http://nistune.com/docs/Installation_an ... ostics.pdf

Every possibility is covered here.

Closing particular windows in the software should not affect anything with comms. Stream mode is more resistant to noise due to less checking of data and one directional information