Nistune Forums

Hi guys, I was just wandering if any of you had a similar experience.
I've been using the ostrich emulator for a while now, initially I had a problem with the car cutting out after driving for a while, this got solved once I've installed a socket booster.
But Friday whiles on the Dyno I lost connection with the emulator, after a while I could get Nistune to connect to it again but it seemed like there's no connection between the emulator and the ecu.

I tried the emulator on another ecu I have without the socket booster but still the same result, just the aircon fan coming on when the ignition is switched on.

Is the ostrich cooked? Any ideas would be greatly appreciated.

Thanks Charl.

Use the Moates reset utility. Or use the 1.2.7 version of Nistune.

Too many changes to the ostrich corrupts its bank settings and they need resetting. I put in detect and fix in the 1.2.6 version of Nistune

Matt wrote:Use the Moates reset utility. Or use the 1.2.7 version of Nistune.

Too many changes to the ostrich corrupts its bank settings and they need resetting. I put in detect and fix in the 1.2.6 version of Nistune

Thanks, done.