NIStune 0.90118 now available

Matt · Post by **Matt** » Sun May 06, 2007 2:35 am

Version 0.90117 has Innovate MTS wideband fixes in it

Version 0.90118 is the start of getting knock sensing and maps added to NIStune

Support now for
VLT RB30ET (must have knock sensor board installed)
Z31 VG30ET (1986-1989 only)
S13 CA18DET
*Added new register to firmware for separate timing knock map indicatiion. Current boards dont have this register so only fuel map will display
R32 RB20DET
M30 VG30DET
Z32 VG30DET
* Does not differentiate between high gear/reg gear maps. I'm running out of registers to flag this

Looking into the SR20DET next. Address 000C has the knock DTC value (has 0x40 set if good, clear if knock sensor input out of tolerance). But I can't generate 2.5Khz on the bench currently to test this (doesn't get through filtering). Need a frequency generator capable of this so looking into it

Fusion Ed · Post by **Fusion Ed** » Sun May 06, 2007 6:18 am

Could you make a 2.5K test tone from an audio program etc..

Matt · Post by **Matt** » Mon May 07, 2007 10:56 am

Was thinking about it... but got another signal generator today. trying that out tonight

Fusion Ed · Post by **Fusion Ed** » Mon May 07, 2007 11:02 am

Yeah test gear is always easier, but i have in the past used the pc to make all sorts of audio test tones etc using cooledit