R34 Gtt - auto sedan - stagea tuned image
Posted: Sat Oct 25, 2014 8:27 am
So Im new here.
I purchased and installed nistune and have only really played with it offline.
I have a tuned base image from pete at plms.
My mods are :
Stock neo engine
Stock er34 maf
Stock injectors
Stock turbo ( 10-12 psi )
Stock fpr
Stock fuel pump ( gss342 walbro waiting to go in direct wired)
Blitz sus intake
Blitz se Fmic
Blitz nur spec cat back
Blitz dsbc
Turbosmart recirc
I have aem wideband ( not connected to nistune yet)
My goal is to have a very nicely running car.
Id like to have 12.5-13 : 1 AFR or there abouts.
Im in canada so I use shell vpower 91 aki ( oct ) fuel
Have started playin around offline so I can understand how to use nistune.
But now would like to start getting it ready for next spring.
Mechanically its been gone over. i think the only thing I still have to do it the timing belt kit and alternator voltage regulator. ( my voltage is not stable )
But other then that I think Im good to go.
So my question is : after loading petes tuned file where do I begin?
I have read thru the tutorials and some of it leaves me with more questions then answers.
I dont have a specific hp goal ( tho it is reported I should have about 200-220 kw) More or less i just want to liven it up abit and make use of the breather mods, and fine tune it.
Any ideas?
I purchased and installed nistune and have only really played with it offline.
I have a tuned base image from pete at plms.
My mods are :
Stock neo engine
Stock er34 maf
Stock injectors
Stock turbo ( 10-12 psi )
Stock fpr
Stock fuel pump ( gss342 walbro waiting to go in direct wired)
Blitz sus intake
Blitz se Fmic
Blitz nur spec cat back
Blitz dsbc
Turbosmart recirc
I have aem wideband ( not connected to nistune yet)
My goal is to have a very nicely running car.
Id like to have 12.5-13 : 1 AFR or there abouts.
Im in canada so I use shell vpower 91 aki ( oct ) fuel
Have started playin around offline so I can understand how to use nistune.
But now would like to start getting it ready for next spring.
Mechanically its been gone over. i think the only thing I still have to do it the timing belt kit and alternator voltage regulator. ( my voltage is not stable )
But other then that I think Im good to go.
So my question is : after loading petes tuned file where do I begin?
I have read thru the tutorials and some of it leaves me with more questions then answers.
I dont have a specific hp goal ( tho it is reported I should have about 200-220 kw) More or less i just want to liven it up abit and make use of the breather mods, and fine tune it.
Any ideas?