Page 1 of 1
boards have arrived
Posted: Tue May 15, 2007 12:49 am
by Fusion Ed
Matt, My boards arrived today, thanks. I hope to have one in a car by the end of the week to see how they do.
Another question, now much more of ma09 rom has been learnt, would the type 1 board now be compatible with this ecu for consult and live remapping?
Cheers,
Ed
Posted: Thu May 17, 2007 7:33 pm
by Matt
I still have to run through all the consult addresses now for this... but yes it is compatible with the Type 1 boards based on the photos and ROM disassembly
Once I have consult addresses worked out can then program that into a firmware file and put into a board
Still a bit of work to do on this. I've been interstate this week so catching up on emails/forum postings will have to be next week
Posted: Fri May 18, 2007 3:04 am
by Fusion Ed
Cheers for the update. Thats fine
Posted: Fri May 25, 2007 1:11 pm
by Matt
Is this all working now?
Posted: Fri May 25, 2007 9:56 pm
by Fusion Ed
I tried a second board in another ecu. That worked fine. I ahve not tried the first board in the second ecu to see weather its the ecu or board, however I suspect its just the ECU.
Ed
Posted: Mon May 28, 2007 1:30 pm
by Matt
make sure the ECU has all 2x20 pins installed in it. missing pins like used on earlier PLMS boards will stop NIStune boards working
Posted: Tue May 29, 2007 1:22 am
by Fusion Ed
It has all the pins!! I would have spotted that a mile away