Page 1 of 1
06E905115e vag coil into ca18det as upgrade
Posted: Fri Jan 09, 2015 10:35 am
by jks1customs
Hi Matt if I plugs those 06E905115e vag coil pack will nistune be able to adjusted the ignition dwell ??
I know they work as been wire into a diferent ecu management and the car starts but I want to map it you can tell me please
Thanks
Re: 06E905115e vag coil into ca18det as upgrade
Posted: Fri Jan 09, 2015 11:30 pm
by Matt
As long as you know the duty time of the coil pack, then you can adjust the dwell vs volt table to suit those coils. I'm not familiar with different coils apart from the widely discussed LS1/LS2 on this forum to know their dwell time required
Re: 06E905115e vag coil into ca18det as upgrade
Posted: Sat Jan 10, 2015 6:38 am
by raddy
Im using vag tfsi coils (differ.partumber from yours) and they are happy with stock dwell table.
Re: 06E905115e vag coil into ca18det as upgrade
Posted: Thu Jan 29, 2015 5:56 am
by jks1customs
I was planning to map my ca18det to 500bhp so I know they would work but needed to know if they can be adjusted I am looking at the ls1 coil pack options as I can buy 8 stock one for very very cheap
MATT whats the dwell timing and the info I need to know for the stock factory ls1 coilpacks ??
Re: 06E905115e vag coil into ca18det as upgrade
Posted: Wed Mar 11, 2015 5:20 am
by Croustibat
From what i gathered, ls1 coils have a positive trigger, while ls2 coils have a negative trigger, so better go for these ones. The ls2 truck coils also have a radiator to cool the integrated igniter. I found the dwell time is 5ms on them, which is long; but it seems they can hold a 1.1mm gap with 1.5bar boost, so unless you are planning to rev a lot higher than 7000rpm, it should be ok