Nistune Forums

Posted: **Wed May 30, 2007 3:23 am**

Hi guys,

after a 8 month of break with the whole Z31-mapping stuff i am back again with fresh engine and lots of motivation. I downloaded the latest version of the nistune software (0.90119) and registered with my personal key. Then when i want to open an "adress file" the following message occurs:

"Errors in address file cannot process"
"Error: ROM ORIGIN is not specified"

Please can you help me Matt. Thanks.

Dino

Posted: **Wed May 30, 2007 1:10 pm**

yep. you are using an old address file

in the email i send you recently should be an address file for 86-89 Z31. use this one instead and it should all be good...

Posted: **Wed May 30, 2007 6:51 pm**

thanks Matt,

due to problems with our email-server no email from you arrived.

Could you please send it again to my private address: "dino.rockstroh@gmx.de"

Thanks again.

Dino

Posted: **Fri Jun 01, 2007 10:44 pm**

Matt, can you please send again the address file to my following address:

dino.rockstroh@gmx.de

Thank you

Posted: **Sun Jun 03, 2007 7:01 pm**

sorry about the delay. this has now been sent to both addresses

Nistune Forums

Problem when using nistune after install latest version

Problem when using nistune after install latest version