Under part3. How do I adjust for different injector size? I tried to follow the directions and they wouldn't work. I worked around it so I thought I would share it with everyone. Also to be sure it is correct.
I was working offline so I wasn't hooked to my ECU if that makes a difference.
Starting with "Several steps are involved..."
1. when you open your fuel map and fick the 'flags' box the veiw automatically changes to A/F Ratio.
2. When I highlighted the upper left corner I could not change the value until I changed the view back to Raw values. To set the value to 14.7 change the box to 0 instead of 1.
3. Highlight the bottom left corner and using 'shift/arrows' highlight the grid moving up and to the left until you end up in the top right cell. This should remain highlighted. Click 'control/f' to fill all the cell with the 0 value.
4. Reset the view type to A/F ratio to check what you have done.
This should let you adjust your K value to get as close to 14.7 as the FAQ states. Just wanted to be sure this will work. Now I'll go try.
Problem with procedure in FAQ
Moderator: Matt