Software ignition offset?

Fusion Ed · Post by **Fusion Ed** » Mon Jun 18, 2007 7:19 am

Is there anyway I can correct the ignition map by for example adding an offset value in the adr file, to bring the ignition in sync with the map with what the engine is doing? Obviously I could alter the distributor to sync this up properly, but there is a specific reason that I don't want to do this for now, and want to make the map to read what's going on in real life..

Matt · Post by **Matt** » Mon Jun 18, 2007 12:07 pm

Have a look at the CA18 address file. We offset the ignition table there.

This will show up when you are in 'filtered' view ignition timing table. It will not change the raw view display

Fusion Ed · Post by **Fusion Ed** » Mon Jun 18, 2007 12:55 pm

Thanks Matt, I shall give this a go.