fuel cut - fuel recover type VLT non FP

[bachig24u]

Hi Matt,
Today I tuned dug out one of our trusty VL circuit cars running on old firmware to convert to E85 but found that the
"fuel cut rpm" "fuel recover rpm" parameter in nistune version 1.2.68 are now missing.
I'm guessing the address file is the issue.

The engine has an issue when the throttle is held at low rpm, around the 1500 mark, it performs a dfco and injection recovery which ias why I need to change the settings.

Can you assist getting them back?
I tried swapping config from Expert to the other modes but still nothing listed.

Kind regards
Simon

[Matt]

I'm not sure why I removed these two lines:

#Limit maps
FUEL_RECOVER,&H0000,0,0,0,0
FUEL_CUT,&H0000,0,0,0,0

However if you comment out these lines with # inside VLT_RB30ET_E.adr file then it will show the tables

[bachig24u]

Thanks for the expedient reply Matt.

Its all sorted.

much appreciated.

KR
Sime