Nistune Forums

Hi, im newbbie with this, so.. i try to make so explicit.

I do this:

1) Install Nistune on ECU
2) Install Nistune on PC Win 10
3) Check Drivers, is fine, windows take "type 1 board" when car is Ignition On and engine OFF.

Try to donwload, burn or upload says "consult is not connected"

I check online and CA18DET 44F07 dont use consult cable, only the USB A-B.

4) Use a brand new USB cable, the same.
5) Try to change ( on pack map) the injector or maf size and says " ingnition must be on, and engine OFF" ( The car ingnition IS on, and engine off)
6) turn On the engine, and any gauge or log are in blank even when try to select gauges or "colors" ( in log mode) the list are empty

I Asume for any noob thing i cant connect nistune with the ecu, but windows take it.

I appriciate any help

Try adjusting the usb female plug into the side of the ECU. There should be two screws on the plug hold down. I had to adjust mine with the cable plugged in and worked perfectly after.

Hi cmbz i do this, also recheck all welderings and connections same thing

i try on DLP and he saw the ecu, but nistune still cant connect.

Try to donwload, burn or upload says "consult is not connected"

You missed a vital step.... actually connecting to the ECU.

Please press the 'consult' button in the top panel (2nd from right) to connect before attempting to do anything

If still an issue after this then please do a debug log and post it here (File > Config > Debug logging)

Matt wrote:

Try to donwload, burn or upload says "consult is not connected"

You missed a vital step.... actually connecting to the ECU.

Please press the 'consult' button in the top panel (2nd from right) to connect before attempting to do anything

If still an issue after this then please do a debug log and post it here (File > Config > Debug logging)

I know it!!! I know it is was a silly mistake

I connected, and problem solved

thanks matt!