Nistune Forums

Hey guys,

Have a stock rb30et with a base rb30et map loaded....under a full load pull, not necessarily to rev limiter, this message is logged each time

CAUTION: ecu load (tp) max reached. Injection limited. Increase table values

What can cause this on a standard map with a standard setup?

Thanks

Warning means that TP value has hit the standard TP max limit map. It is just a warning in case you are concerned injection isn't going any higher.

Thanks Matt,

This is an unmodified engine with an unmodified nistune map.

Not something I should be immediately concerned about prior to getting a tune?

Thanks

From what you described, I don't think so. The TP max maps are fairly low but those ECUs are tuned for low boost also (thinking 6-8psi factory?)

Yep. 6psi

Thanks for the reply