Type 1 board preprogrammed for type 2 ECU

[midian]

Hi all, I definitelly sure I'd read here (or at z31p forum - not sure exactly, pretty sure it was here) that it possible to use type 1 board in type 2 ECU.
I also remember Matt confirmed this, but I can't find topic =(
I have nistune base image programmer, so can DIY.

So, I don't remember what should I do - simply upload base image with ADR on bord, or some extra.

[Matt]

Most probably not. It depends... F700-F7FF is reserved on most Type 1 boards for USB comms. So if the Z32 image uses that address area for its own program code then it wont work