Nistune Forums

Hello!
I've made tcp<->consult bridge over WIFI. Using diy consult wifi adapter and Tibbo virtual COM driver.

Works like this:
https://youtu.be/UT316hFZfOg

Made a lot of work in tuning tcp/ip stack for minimal delays and fast connect. Now it is near as fast as wire connection and twice a time faster than BT in Tuner Mode: Is such an adapter can be usefull? Full halvanic isolation and easy connection. In theory, if Nistune SW will support TCP connection with custom delays, it can yeild in much speed improvement in Tuner Mode.

Nice work!

The main delay is the speed of the consult which is limited to 9600bps (1200 characters/sec so 1.2 char/ms)

We can increase the clock rate in the processor to a higher rate, but then this needs to be done both sides (in firmware, and software) to match. If the rate is incorrect one side then there are no more comms. I think we can up to about 19,200 but I would need to check the 6303/7790 datasheets

Hello, Matt! I was PMd you to mail address in your contacts(@yahoo). Or, please, PM me, how I can contact you.

Got the email thanks

Support added (for testing) in 1.3.35 for Wite