Page 1 of 1
RBZ32 bin and log file
Posted: Sun Sep 04, 2022 7:02 am
by Frezzingcold1
Hi Matt, here's the files you asked for.
Re: RBZ32 bin and log file
Posted: Mon Sep 05, 2022 2:53 pm
by Matt
the ecu you repaired for me everything is working normally but the engine will not rev past 1800 rpm it just surges. Nistune shows the maps its using is in the green there are not any red warnings on the gauge screen and no amber warnings. I have the hpxn1 with a 3" tube 500hp load 800cc injectors. I will swap out my AFM from the gtr to the rb25 to see if that makes a difference. All vacuum lines are new there are no vacuum leaks. I'm at a loss with this at the moment this car has been fighting with me every step of the way
Re: RBZ32 bin and log file
Posted: Mon Sep 05, 2022 3:01 pm
by Matt
Can see the cuts around 6-7ms injection time, since TP index around 54. Need to check on the bench
Re: RBZ32 bin and log file
Posted: Mon Sep 05, 2022 3:58 pm
by Matt
Seems to be constant, regardless of MAF and RPM or TPs voltage
Noted things:
- There is no speed input (but safety load limits set higher)
- Latency seems low (wont affect this)
- fuel map needs adjusting for 800cc
When did this problem start happening? I would need the board here. Will contact via email
*Cannot repeat issue on the bench setup