Page 1 of 1
Adding new CA18DET table
Posted: Fri Dec 07, 2007 4:06 am
by LMQT
At 3EE0 (to 3EEF), there is a START ENRICHMENT TABLE which isn't in Nistune.
How can we add it ?
Does it need a mod in the programm ?
The scale is -40°C to +110°C step 10 (like 3EB0 table) AFAK.
Posted: Fri Dec 07, 2007 9:41 am
by Matt
you have your choice of the following address file entry lines to use
"AS_ENRICH"
"AI_ENRICH"
"WARM_START_ENRICH"
"COLD_START_ENRICH"
"TEMP_ENRICH"
These are the temperature range you require for X axis and a % range on the Y axis
Just add it to your address file and should show up next time you load NIStune
Posted: Fri Dec 07, 2007 7:41 pm
by LMQT
Do you have the correct addresses with those 5 new lines please ?
I think I've got an old (very old) address file, could you resend me please ?
Or someone else because you're away from today to 13 december
Seconde question, could you explain how thoses 5 tables are functionning please ?
I guess a lot of people on this board doesn't know, so it could be helpfull
Posted: Fri Dec 14, 2007 6:18 am
by LMQT
no one knows those tables in CA18DET ?
Posted: Sun Dec 16, 2007 12:17 am
by Matt
Probably not yet. Is the enrichment for cold/warm start? See the discussion thread
viewtopic.php?t=390
so use the following for now
TEMP_ENRICH,&H3EB0,16,1,16,1,Coolant temp enrich
WARM_START_ENRICH,&H3EE0,16,1,16,1,Start enrichment
Can you paste the code where you see this access at 3EE0. I couldnt find it in my disassembly
Posted: Sun Dec 16, 2007 12:26 am
by LMQT
Matt wrote:Probably not yet. Is the enrichment for cold/warm start? See the discussion thread
viewtopic.php?t=390
so use the following for now
TEMP_ENRICH,&H3EB0,16,1,16,1,Coolant temp enrich
WARM_START_ENRICH,&H3EE0,16,1,16,1,Start enrichment
Can you paste the code where you see this access at 3EE0. I couldnt find it in my disassembly
OK, I go on by PM, you'll put here the result of our discussion when it will be good
Posted: Sat Jan 19, 2008 9:04 am
by Vetal
How did this all end? Can you confirm CA18 has START ENRICHMENT TABLE?
Posted: Sat Jan 19, 2008 4:29 pm
by Matt
LMQT was looking into it. I didnt add that one to the investigate list yet
Posted: Sat Jan 19, 2008 7:40 pm
by LMQT
Sorry but I'll can't investigate further more : 200SX has gone
...
And Camaro Z28 is arrived with Christmas
Posted: Mon Jan 21, 2008 9:28 pm
by Vetal
Congrats
I also finally bought my dream car - TransAm with LS1 5.7 engine
Although I'm not planning to sell my S13 - too much time put in it