Nistune Forums

Matt,
It seems that the last couple of versions of Nistune have this problem. When I go to feedback switch and check all the boxes to turn off the feedback (FF) it doesnt seem to save the changes. When I reopen the window all the settings are back to their normal state. Also, why did you change it to the check boxes from the slider/single value type?

Found this out as I was trying to make changes just before leaving on vacation. Actually fixed it up whilst the misses was driving back home. It has to do with that the temp ranges went -30 to 120 and it didn't like anything negative

I've fixed it up tonight and is available in the beta version I've uploaded. See main discussion thread for location of this version

make sure address file is not using FB_SWITCH any longer. The switch applies to 8/16 bit ECUs but the O2 Temperature feedback is a new parameter (using the current memory location you were using previously)

viewtopic.php?t=443