Website Updates etc
Posted: Sat Mar 15, 2008 11:36 pm
If you havent noticed yet website is updated!
I've tested all the links out. Let me know if any problems, suggestions etc. All the ROM images for the boards we support are in the downloads sections. We will be updating some of the manuals as we get time also
There is a workshops list for tuner license holders. Let us know if your details need updating / fixing at all
New versions will be on the updated downloads page
Pete is doing the final touches on Type 4/5 boards and getting shipped off for prototype PCB manufacturing
So I am back on working software again...
Main items are putting timing fix in for CA18 and knock sensing capability investigation has hit the top of the list again (as well as fixing urgent bugs)
I'm looking at native ECU knock sensing and getting Pete to scope out his TXS knocklite over the next week. We received no feedback from the suppliers so are on our own working out the protocol. (Technical : Its TTL level logic RX output so we assume it just streams knock information)
Shouldn't be too hard though but it may need a TTL - Serial adaptor (like Max232 or directly into FTDI232RL chip on a board and going via USB)
Thanks for your feedback and support!
Matt
I've tested all the links out. Let me know if any problems, suggestions etc. All the ROM images for the boards we support are in the downloads sections. We will be updating some of the manuals as we get time also
There is a workshops list for tuner license holders. Let us know if your details need updating / fixing at all
New versions will be on the updated downloads page
Pete is doing the final touches on Type 4/5 boards and getting shipped off for prototype PCB manufacturing
So I am back on working software again...
Main items are putting timing fix in for CA18 and knock sensing capability investigation has hit the top of the list again (as well as fixing urgent bugs)
I'm looking at native ECU knock sensing and getting Pete to scope out his TXS knocklite over the next week. We received no feedback from the suppliers so are on our own working out the protocol. (Technical : Its TTL level logic RX output so we assume it just streams knock information)
Shouldn't be too hard though but it may need a TTL - Serial adaptor (like Max232 or directly into FTDI232RL chip on a board and going via USB)
Thanks for your feedback and support!
Matt