Map Copy Feature (Main Fuel Map to Gear Fuel Map)

JasonKemmerer · Post by **JasonKemmerer** » Sun May 11, 2008 8:39 am

I find myself directly copying cell info from the main fuel map to the gear map all the time. It would save me precious dyno time if there was a feature to copy the main fuel map data to the gear fuel map data, just like the knock copy. That would be awesome.

thanks

JasonKemmerer · Post by **JasonKemmerer** » Tue May 13, 2008 12:52 pm

Would this be somewhat easy to do?

I guess it could be done manually in hex but kind of a pain.

Matt · Post by **Matt** » Tue May 13, 2008 1:52 pm

Yeah I can do that.

You can also CTRL-A (select all) then copy/paste, but button would be easier

JasonKemmerer · Post by **JasonKemmerer** » Tue May 13, 2008 5:34 pm

Matt wrote:Yeah I can do that.

You can also CTRL-A (select all) then copy/paste, but button would be easier

Awesome, I didn't even think of doing it like that

Button would be even better.

Matt · Post by **Matt** » Tue May 13, 2008 8:04 pm

I tried to make the grid quite flexible

The only thing havent done is cut/paste in AFR modes etc. Its difficult because you dont carry across the O2/knock flags if you do this

Its on the list...