USB driver install??
Posted: Sun May 11, 2008 10:29 pm
Hi All, please forgive my ignorance, I'm a newbie here. Finally got my car started again yesterday after installing the engine with some mods and am now trying to get Nistune running.
I have a Z32, type 2 board (not yet installed), and a USB consult cable which I'm trying to use to setup some basic items such as TPS before getting to work with Nistune.
The problem I'm having is that my W2K laptop will not install the driver for the Consult cable and I'm having difficulty finding any reference to the correct procedure. 'The specified location does not contain information about your hardware' or similar is the error I'm getting. W2K sees the cable, the red light comes on, but it just won't accept the driver.
Have I missed something?? Can anyone point me to the correct installation procedure? Or do I have to install the Type 2 daughterboard before attempting to connect and use the Consult cable?
Hope someone can help.
Thanks in advance.
RobH
I have a Z32, type 2 board (not yet installed), and a USB consult cable which I'm trying to use to setup some basic items such as TPS before getting to work with Nistune.
The problem I'm having is that my W2K laptop will not install the driver for the Consult cable and I'm having difficulty finding any reference to the correct procedure. 'The specified location does not contain information about your hardware' or similar is the error I'm getting. W2K sees the cable, the red light comes on, but it just won't accept the driver.
Have I missed something?? Can anyone point me to the correct installation procedure? Or do I have to install the Type 2 daughterboard before attempting to connect and use the Consult cable?
Hope someone can help.
Thanks in advance.
RobH