Nistune Forums

Have some questions on the M30 address file that is included with Nistune.

1. I have an old M30 address file also from before Nistune. I have noticed that both the old file and your Z32_VG30_256_E address file have HighFuel 7D00 and RegFuel 7000 where the Nistune M30 address file has HighFuel 7D00 and RegFuel 7400.

2. I have also noticed that both the old file and your Z32_VG30_256_E address file have HighFire 7800 and RegFire 7C00 where the Nistune M30 address file has HighFuel 7C00 and RegFuel 7800.

So which is correct?

Will the Feedback control, Acceleration increase volume, TP Limit and a few other maps from the Z32 address work with the M30 ecu?

Also, should the Version=1 be Version=2? This is the type 2 board in this ecu.

Let me have a look at them. The Z32 has been continously updated, but the M30 may need some changes, I'll compare the code this weekend and make updates to the M30

Sorry still to look at this. I've had relatives over our place this weekend so havent been able to get much done

At least you did not forget me.

Dont need to worry about that... I put everything on my bug/enhancement spreadsheet that gets raised here so I can keep track of it

I've gone through that address file. The knock timing map doesnt exist on that ECU. More parameters have been added. Most very simiilar to the Z32

The fuel maps and all the scalers were correct addesses. See the latest ROM/address pack uploaded last night for an updated file