consult not connected

quickgtir · Post by **quickgtir** » Sun Jun 08, 2008 9:40 pm

Hi there,

i am using the blazt-serial connecting cable, until now i was just working with nissan data scan with which it was working perfectly. Now i am trying to use the blazt cable to connect to NisTune, but always i get the message "consult not connected".

Matt · Post by **Matt** » Sun Jun 08, 2008 11:19 pm

What vehicle / engine are you trying to connect to?

Which address file are you loading?

quickgtir · Post by **quickgtir** » Tue Jun 10, 2008 5:34 am

Hi Matt,

using it for an RNN 14 with sr20det. Have the Adressfile of S13. have any idea?

thanx
Jakob

Matt · Post by **Matt** » Tue Jun 10, 2008 11:19 am

So NissanDataScan connects okay with the board installed but NIStune doesnt connect at all?

Can you please send a debug log through to me (see sticky in software thread)

quickgtir · Post by **quickgtir** » Mon Jun 16, 2008 5:31 am

i am using a USB to Serial converter no, and it is working.

thanx matt

Matt · Post by **Matt** » Mon Jun 16, 2008 12:55 pm

Okay. Bit strange. So before, just plugged into serial port wasnt working but now using USB-serial it works fine?

If you still want me to look into it, let me know and I can have a look through the debug log file

Nistune Forums

consult not connected

consult not connected

for RNN 14