Page 1 of 1
Whats stock boost for S13 S14 SR20DET
Posted: Wed Aug 13, 2008 5:08 am
by UNISA JECS
Hey Matt got a simple question what is the factory boost pressure for the above mentioned vehicles when they come off teh dealer lot?
More here on this:
http://zilvia.net/f/tech-talk/208005-wh ... 20det.html
Posted: Mon Aug 18, 2008 3:41 pm
by Matt
Checked with PL on this one since I only work the software/firmware side of things...
8 to 10psi is the answer for S13. The stock WG actuator spring gives 7 to 8 psi. But then there are two brass bleed jets hidden in the hoses that give you your actual boost level. The ratio of the two jet sizes determines the boost level – not the friggin solenoid
Stock boost is very hard to nail down cos you only need to fart and it’ll change. Have a look at the graphs for Graeme’s dead stock S15. All I did was tune the fuel and IGN maps a bit and boost crept up by over 1psi – no other changes. This proves that a stock S15 is 8psi though!
http://www.plmsdevelopments.com/customers/gf_s15.htm