Nistune Forums

How about a customizable quick view window at the top of the NIStune window to show the same values that the "multiple consult gauges" window shows. eCtune uses something similar to this which works well. I have attached an example.

Values are green when safe, then could change to yellow when borderline, then red when warning.

This would allow a lot of information at a glance while being able to tune at the same time.

On the grid view you see with those blank fields - you can set those up to show the various consult parameters (such as AFRs, timing etc)

There is a mapgrid configuration window available under the Operation menu

The only difference is that the grid view takes up the whole screen, the other would allow you to see that same data with minimal space taken up in the window.