Page 1 of 1
cant change loadscale
Posted: Fri Nov 07, 2008 1:53 am
by Mads B (dk)
i cant change the loadcells in ignition maps, works fine in fuelmaps
Posted: Fri Nov 07, 2008 10:17 am
by PL
Have you tried changing the load scale values by selecting the load scales in the left menu rather than editing directly in the IGN maps?
PL
Posted: Fri Nov 07, 2008 3:18 pm
by Mads B (dk)
yes i have tried that but every time i push the buttom the value jumps 17 points up..... and its always up even when i push -/pagedown
Posted: Sun Nov 09, 2008 9:49 pm
by Matt
okay click on the cells below the scale, and then use the up key to move into the scaling bar area
this will then let you change the scaling using +/- keys
Posted: Mon Nov 10, 2008 9:31 am
by PL
I tested this on the weekend by programming a 39F00 base image into a type 1 board and running it on the bench.
I was able to change load scale values by selecting the required cell (it goes dark blue) in the load scale editing box and using +/- keys to adjust.
No problems this end.
PL
Posted: Mon Nov 10, 2008 10:02 pm
by Mads B (dk)
it works
, but in fuel maps i just dual click on the value and i can write any number value
today in found out that i have same problem in every scale
jumpes 17 up regardles if push -/+/pageup/pagedown
i triede to edit in a s13 sr20det map with the right adr. file of coause no problems at all
Posted: Mon Nov 10, 2008 10:06 pm
by Mads B (dk)
i can change rpm scale's same way i change load scale's from ign or fuel map.
Posted: Fri Nov 14, 2008 8:19 am
by Mads B (dk)
No one else with this problem ?
Posted: Sun Nov 16, 2008 7:44 pm
by Mads B (dk)
hmmm... it works on my brothers computer... so it must be a problem relatet to my computer
Posted: Sun Nov 16, 2008 9:49 pm
by Matt
never seen that problem. so if you move the cursor into the scalers using the keyboard it still doesnt adjust?
what is the DPI on that computer under Display properites?
