VEMS not working with nistune

iceblade · Post by **iceblade** » Fri Mar 06, 2009 7:50 am

Ive got my vems afr/egt guage all up and running via seriel to usb adaptor, works fine with the megatune software that comes with it, but nistune cannot connect to it,
if i go into the config settings it knows the vems gauge is on com 7 (same as it shows on my laptop in control panel) but when i try to connect using the "WB02 LH" button it says "vems could not connect to com 8"
ive tried chaning com ports but it always sayscould not connect to 1 port higher than i am using....
quite frustrating to tell the truth....
any deas whats going on???
thanks
Joe

Matt · Post by **Matt** » Fri Mar 06, 2009 5:59 pm

i did some changes to com ports in recent two versions. i must have missed VEMS from those updates in all the wideband units.

Quick change i'll get that up this weekend

iceblade · Post by **iceblade** » Sat Mar 07, 2009 6:33 am

legend mate

Matt · Post by **Matt** » Sun Mar 08, 2009 3:26 pm

should be fixed in the 0.9.3.6.1 release. tested today and i dont see any problems with that version in regards to connecting. please let me know if still have problems and get a debug log if you do... scratching my head right now trying to work out the issue

iceblade · Post by **iceblade** » Wed Mar 11, 2009 2:05 am

works now thanks buddy, is there any way to change the view from lamda to afr??? os is it lamda only??
thanks matt
Joe

Matt · Post by **Matt** » Mon May 04, 2009 8:10 pm

File- Configuration - Wideband Display Lambda (tick off)