Page 1 of 1
Wiring in consult plug
Posted: Sat May 02, 2009 1:16 pm
by aleks
Just a quick question
I have a CA18 180 with a neo engine. I am going to wire in a consult plug and just wanted to check if I will need the CLK to be wired in (I'm assuming thi is the clocking reference?) because I can't find it in the wirring diagram
So will I need to wire in CLK?
Any help is appreciated.
Cheers, Alex.
Posted: Sat May 02, 2009 2:12 pm
by Matt
yes you need to wire in CLK, TX, RX, 12+, GND
details in here
http://www.nistune.com/docs/Installatio ... ostics.pdf
Posted: Sat May 02, 2009 2:37 pm
by aleks
Anyone know what pin number is CLK for a R34 NEO?
Posted: Sat May 02, 2009 3:19 pm
by aleks
I had to solder from the board thanks to some awesome wiring job
You wouldn't happen to know what pin number CLK is Matt? Neo connector isn't in the installation guide.
Cheers, Alex.
Posted: Sat May 02, 2009 11:41 pm
by Matt
silly me... ER34/WC34 RB25 doesnt have the clk line... just remembered. sorry about that
Posted: Sat May 02, 2009 11:42 pm
by aleks
Sweet, thanks.
Posted: Sun May 03, 2009 1:19 pm
by datsunboy
Is there any point to wiring a consult port into a CA18?
I thought they didnt have consult?
or is this for a Nistune CA ecu?....then whats the benfit of a consult port?
Posted: Wed May 06, 2009 3:34 pm
by aleks
I have a CA model 180... it never had a consult plug.
It now has RB25 neo (type 4 board) so I had to wire in a consult plug for it as only the type 1 boards have the usb consult add on.
Posted: Thu May 07, 2009 12:52 am
by Matt
engine conversion
Posted: Thu May 07, 2009 12:06 pm
by datsunboy
so obviously you got rid of the CA18 loom when you changed to an RB25....so if you used the RB25 loom, wouldnt that have a consult plug???
Posted: Sat May 09, 2009 5:49 pm
by aleks
aleks wrote:I had to solder from the board thanks to some awesome wiring job
Not my work