Nistune Forums

Matt wrote:There will be no FP for CA18ET ECUs. There simply are not enough boards sold to justify the time and expense developing for some lesser used models

ok thank

hi

the function flex fuel is not always available for the CA18ET?

thank

Thanks for the feedback! With the models supported, I chose the most common ones. With CA18ET we do not sell many boards for that model (N13 CA18ET?) so I cannot justify the time to allocate to that vehicle sorry. ok, thank for answer, We will see later with the evolution of my bluebird To begin, I...

Hello

Again congratulations for your work, I am the evolution of Nistune for almost 10 years and I love the result accomplished.

But, I have a question, he are possible of make function the nistune with the function flexfluel on a ECU of CA18ET?

Bluebird T72 years 1990 european

thank you

That connector is just for displaying LED codes on an external device. There is no consult capability at all on these ECUs which is why Type 1 and special firmware was developed to emulate some of the original consult capabilities (DTC codes, register display as well as tuning updates) :cry: ok, th...

Hi

I have a service manual Nissan CA18ET
I noticed in the page ECCS circuit digram
the location of a check connector
but no connector over the car
would it be possible to set up a consult connector on this model ECU?

Yes, I saw yesterday, despite the years, it's the same version in 24-pin
I can send you one of silvia S12
I understand, nothing is impossible despite 24broches
you can send me the shipping address? I will look for shipping

Yes I need the chip removed from the ECU and read using an EPROM programmer so you can email me the BIN file I just see that a French sellers is in your liter "Workshops / Regional Distributors" I will contact, it may be you can transfer data from the chip http://www.nistune.com/ordering-...

Nissan Bluebird turbo CA18ET U11T, made ​​in June 1984

I put a pictures of an ECU

Nissan Silvia S12 CA18ET, made in April 1988

catalyzed version, oxygen sensor, EGR and charcoal filter

Matt wrote:looks same as a Z31 ECU. Just need the BIN file from the 28 pin chip on that ECU to check it here

sorry for my absence
you want the data from the chip?
I will gather additional pictures

hello sorry for the delay Pictures of ECU de CA18ET Silvia S12 1988 years http://img691.imageshack.us/img691/6342/img0098mvw.jpg http://img715.imageshack.us/img715/4851/img0097y.jpg http://img191.imageshack.us/img191/2425/img0099al.jpg http://img820.imageshack.us/img820/5699/img0100z.jpg http://img6...

not sure on the S12 one. 21F13, 33F01 and 30F10 is what I have here the 23710-33F01 and 33F02 are version european no-catalyst i would need you to remove the ROM chip, read out the image using an EPROM programmer and send the BIN file through you talk using this equipment? http://img138.imageshack....

beautiful install

ok, it's just info sensor and actuator

it is already good.



I have reference my S12 ECU is 23710-24F01
I wanted to open the lid of the ECU for a photo, but a screw is dead,
I'll look later
I have a Bluebird with CA18ET in my garage, I look to the tomorrow reference


thank