Hi Matt.
Your probably not aware, but i sold the z32 back in January, and just last week had my r32 written off (They havent done it yet, still driving it). I'm looking at buying a 99 wgnc34, rs 4 S (manual), obviously with the NEO engine.
What i need to know is if its possible for you to supply and fit a type 4 board for me, but on an exchange basis as i couldnt do with out a car for the time it would take to send the ECU down and back.
No doubt i will need another consult lead with the OBD2 plug as well.
Thanks in advance.
Ken Bamblett
Stagea
Moderator: Matt
Re: Stagea
hi Ken
Best to email me about this as opposed to posting on open forum. I can organise an exchange board plus the cost/postage differences. You will need a standard consult cable. Being an RS4 concerns me since I dont think we do those ones. Would need the part number from the ECU casing to check
Best to email me about this as opposed to posting on open forum. I can organise an exchange board plus the cost/postage differences. You will need a standard consult cable. Being an RS4 concerns me since I dont think we do those ones. Would need the part number from the ECU casing to check
Re: Stagea
Hi Matt.Matt wrote:hi Ken
Best to email me about this as opposed to posting on open forum. I can organise an exchange board plus the cost/postage differences. You will need a standard consult cable. Being an RS4 concerns me since I dont think we do those ones. Would need the part number from the ECU casing to check
Didnt have your email address and your PM's are turned off.
I thought it was the c34's with the neo engine that could be done.
Wasnt looking to exchange the board, i'll keep the r32. I was asking if you could fit a board to and ECU you might have there, send it to me and them i'll send you my ECU as an exchanger unit.
thanks.
ken
Re: Stagea
Use enquiries [at] nistune.com for email. Yeah PMs were getting way too difficult to manage effcectively (I use outlook folders to sort incoming/outgoing jobs)
I've only got a spare R34 A/T ECU here. Stagea ECUs are hard to come by. I can send a board up or you can send the ECU here once part# is confirmed
I've only got a spare R34 A/T ECU here. Stagea ECUs are hard to come by. I can send a board up or you can send the ECU here once part# is confirmed
Re: Stagea
Matt wrote:Use enquiries [at] nistune.com for email. Yeah PMs were getting way too difficult to manage effcectively (I use outlook folders to sort incoming/outgoing jobs)
I've only got a spare R34 A/T ECU here. Stagea ECUs are hard to come by. I can send a board up or you can send the ECU here once part# is confirmed
Hi Matt.
Part number as per nistune is 23710-0v801
Re: Stagea
That part# is fine. Use the ordering page and put it in there and I can get a board out
Re: Stagea
Boards all mounted and fitted, going good.
Fitting Wide band sensor and GCG hi flow tomorrow, Walpro pump and z32 afm sat. Then the fun starts.
I have now a spare 23710-0v801 if you know of anyone after one Matt.
Thanks again
Fitting Wide band sensor and GCG hi flow tomorrow, Walpro pump and z32 afm sat. Then the fun starts.
I have now a spare 23710-0v801 if you know of anyone after one Matt.
Thanks again