Innovate LC-1 reads 32 all the time in Nistune

[maglito]

but works fine in Logworks.

The correct lookup table is selected.

Does anyone have any idea what is going on?

Thanks

[Matt]

This was already raised in the bugs section. Back in adelaide and finished most of my consult and wideband rewrite. Will retest tomorrow with innovate

[maglito]

This was already raised in the bugs section. Back in adelaide and finished most of my consult and wideband rewrite. Will retest tomorrow with innovate

Any word on the retest?

[Matt]

Yes it working now on my development version of the software.

Innovate switches between O2 and Lambda when it senses AFR changes that causes some display mess up for people. That has now been fixed. Also I varied the max with the lookup tables in new version and it responded correctly and Nistune display matches LM-2 display exactly

I'm looking into DLP at the moment since it is slightly off from what my multimeter reads. Wondering if extra translation is requried or if the DLP is not as accurate as I hoped

Other issues with software updates are mutex updates causing freezes at the moment. I'm investigating that. Getting very close to releasing next version however

[maglito]

Good to hear. Do you think it will be ready for release by next weekend?

[Matt]

I'm trying ... been recoding all weekend

At the moment the build is occasionally crashing and has some serious memory leaks which I'm looking into. So its not stable enough for consumption yet. Getting there....

[Matt]

Just marking this thread as fixed