Homemade Twinscroll manifold

[Mads B (dk)]

A small project of mine

http://www.bilgalleri.dk/alb_vis.aspx?albumid=68720

[PL]

Brilliant - I love it!!

I've done a few manifolds from steampipe bends and it works great. Albeit a little time consuming...

What turbo are you using?

PL

[kenbam]

NIce.
Check this out..

http://www.icengineworks.com/icewmain.htm

[Mads B (dk)]

Brilliant - I love it!!

I've done a few manifolds from steampipe bends and it works great. Albeit a little time consuming...

What turbo are you using?

PL

Im runing a cheap china T3/T4 "trim O" @ 1.6bar

[skylinegtrhr]

Nice project we have FR TS GT3076 kit on SR and results are great , we have 0,7 bar on 1800 rpm on dyno
but You should put thermo coating on manifold and DP or You are going to have very high under bonnet temperature.
And make extra braces for turbo as You have down mount which "like" to make cracks on manifold from weight of turbo and vibration of engine.
And if You can go for full TS set up with two WG ...

[Torque]

Im runing a cheap china T3/T4 "trim O" @ 1.6bar

Are these China Turbos any good at all?
I saw many of them @ EBAY ...

[Mads B (dk)]

this one is okay and the most journal bearing turbos are..... but the china roller bearing ones are shit

[Mads B (dk)]

1.8bar boost (on the road i have fullboost at 4500-4700rpm)