my plms cable stopped working recently, i take very good care of it (as its a $100 item).
after my injector swap i tried to change my injectors in nistune, when i plugged it into the laptop the lights did not come on, i kinda messed with it for a minute an found that if i squeezed softly on this one part that it was come on for a second. so i took the plastic wrap off an use a pencil eraser to lightly push around the area that was making it work for a second. i found that if i pressed on this spot with the pencil eraser that it would come on and stay on, here is a picture with the spot circled in red.
it says L1 next to the thing i press on, i think its called a jumper?
so do you think it came loose an just needs re-soldered or what?
to me it seems like a manufacturer defect since in such an odd location an its all wrapped up an stuff, if it was mistreated the whole units more likely to break then just that 1 little thing coming loose or whatever.
anyone else ever have this issue? what should i do? im not forking out another $100 thats for sure.
