NT shows feature pack gauges on non fp board

[Torque]

When I open the consult gauges panel I'm confronted with all the gauges pertaining to the feature pack.
Same goes for the log viewer...

I don't have the feature pack installed,

Z32 ECU/WIN XP/NT 1.2.76

I have not tested this with another laptop/installation yet

[Matt]

Which ones are showing? Screenshot?

[Torque]

I'll do a screenshot later tonight, also will check with another laptop/installation

[Torque]

Tested it with another laptop, same NT version ... issue persists
To my knowledge there is no FP for the Z32 ECU, is it a bug?

[Matt]

Thanks. There is FP for Z32 ECU. Its pulling in some gauges regardless of FP version like 'Flex timing offset' it appears

[Torque]

I thought there haven been issues with the Z32 ECU and the FP, at least last time I checked.
Has this been resolved?

But back to the issue .. it's a bug then?

Have you seen my other post ...?
viewtopic.php?f=8&t=3514

[Matt]

Yes it appears so. Will check it out

FP issue I found was not looking at any map when attempting to switch to knock maps. It was a problem with the patcher which I've fixed. Will be released in the next ROM pack update

[Matt]

Resolved for next version:
http://www.nistune.com/mantis/view.php?id=180