Adding new CA18DET table

LMQT · Post by **LMQT** » Fri Dec 07, 2007 4:06 am

At 3EE0 (to 3EEF), there is a START ENRICHMENT TABLE which isn't in Nistune.
How can we add it ?
Does it need a mod in the programm ?

The scale is -40Â°C to +110Â°C step 10 (like 3EB0 table) AFAK.

Matt · Post by **Matt** » Fri Dec 07, 2007 9:41 am

you have your choice of the following address file entry lines to use

"AS_ENRICH"
"AI_ENRICH"
"WARM_START_ENRICH"
"COLD_START_ENRICH"
"TEMP_ENRICH"

These are the temperature range you require for X axis and a % range on the Y axis

Just add it to your address file and should show up next time you load NIStune

LMQT · Post by **LMQT** » Fri Dec 07, 2007 7:41 pm

Do you have the correct addresses with those 5 new lines please ?
I think I've got an old (very old) address file, could you resend me please ?
Or someone else because you're away from today to 13 december

Seconde question, could you explain how thoses 5 tables are functionning please ?
I guess a lot of people on this board doesn't know, so it could be helpfull

LMQT · Post by **LMQT** » Fri Dec 14, 2007 6:18 am

no one knows those tables in CA18DET ?

Matt · Post by **Matt** » Sun Dec 16, 2007 12:17 am

Probably not yet. Is the enrichment for cold/warm start? See the discussion thread
viewtopic.php?t=390

so use the following for now
TEMP_ENRICH,&H3EB0,16,1,16,1,Coolant temp enrich
WARM_START_ENRICH,&H3EE0,16,1,16,1,Start enrichment

Can you paste the code where you see this access at 3EE0. I couldnt find it in my disassembly

LMQT · Post by **LMQT** » Sun Dec 16, 2007 12:26 am

Matt wrote:Probably not yet. Is the enrichment for cold/warm start? See the discussion thread
viewtopic.php?t=390

so use the following for now
TEMP_ENRICH,&H3EB0,16,1,16,1,Coolant temp enrich
WARM_START_ENRICH,&H3EE0,16,1,16,1,Start enrichment

Can you paste the code where you see this access at 3EE0. I couldnt find it in my disassembly

OK, I go on by PM, you'll put here the result of our discussion when it will be good

Vetal · Post by **Vetal** » Sat Jan 19, 2008 9:04 am

How did this all end? Can you confirm CA18 has START ENRICHMENT TABLE?

Matt · Post by **Matt** » Sat Jan 19, 2008 4:29 pm

LMQT was looking into it. I didnt add that one to the investigate list yet

LMQT · Post by **LMQT** » Sat Jan 19, 2008 7:40 pm

Sorry but I'll can't investigate further more : 200SX has gone

...

And Camaro Z28 is arrived with Christmas

Vetal · Post by **Vetal** » Mon Jan 21, 2008 9:28 pm

Congrats

I also finally bought my dream car - TransAm with LS1 5.7 engine

Although I'm not planning to sell my S13 - too much time put in it