r34 o2 Flags

Pedro · Post by **Pedro** » Wed May 06, 2009 1:08 pm

Am I the only one that cant turn of the 02 sensor flags on the R34

or is it just not possible

Matt · Post by **Matt** » Thu May 07, 2009 12:48 am

O2 feedback sensor flags are not possible on the R34. I've removed the feedback switch options on this ECU in the latest debug version

You will need to change the O2 feedback temp instead

Pedro · Post by **Pedro** » Thu May 07, 2009 11:15 am

where abouts is the o2 temp feedback located ??

aleks · Post by **aleks** » Mon May 11, 2009 10:14 pm

I was thinking this aswell.....

Its not in the adress file

#Feedback control
O2_FEEDBACK_TEMP

Matt · Post by **Matt** » Tue May 12, 2009 1:03 am

O2_FEEDBACK_TEMP,&H2033,1,1,1,1,Feedback control

its in the latest beta version on the site, bundled with the software release

Pedro · Post by **Pedro** » Tue May 12, 2009 10:29 am

Will this effect tuning if I dont do anything with that settings ??

Matt · Post by **Matt** » Tue May 12, 2009 7:53 pm

it will use the O2 sensor feedback and affect your wideband readings at times where its trying to use closed loop

Pedro · Post by **Pedro** » Tue May 12, 2009 9:08 pm

can i just unplug the 02 sensor and tune it

will i need to change the temp settings for tuning then change back when tuning is completed or does the settings stay adjusted for good ?

also what do the settings need to be out to ?

Matt · Post by **Matt** » Sun May 17, 2009 2:38 am

you can unplug the O2 sensor

you can increase the temp to maximum (205 degC which wont be reached). reset this when finished. what ever you change and then burn stays there until changed otherwise