I'm looking at running CDI, specifically a M&W Pro-16B so,
What trigger edge does the computer use/will I need to use?
Can anyone see any problems with this?
Any help is appreciated...
(PS: I don't care that the standard ignition is good for 700kw)
Cheers, Alex.
CDI setup on RB25
Moderator: Matt
see the mapping manual
http://www.nistune.com/docs/NIStune_Mapping_Guide.pdf
page 25 on the PDF has a picture of it under 'Timing Changes'
It is active low signal @ 10 volts to the coil (i believe I was measuring on RB30 here). then when it releases the spike goes upto 20 volts in the reverse direction when the induction kicks in
http://www.nistune.com/docs/NIStune_Mapping_Guide.pdf
page 25 on the PDF has a picture of it under 'Timing Changes'
It is active low signal @ 10 volts to the coil (i believe I was measuring on RB30 here). then when it releases the spike goes upto 20 volts in the reverse direction when the induction kicks in