Adjusting TTpmin/max
Moderator: Matt
Adjusting TTpmin/max
So I finally got around to installing my nistune board in. I have semi dialed in K const for some mototron 60lb injectors. But I have no idea how to figure out the values for ttpmin and max for this injector. Is there a guide or general rule of thumb I should be following?
Re: Adjusting TTpmin/max
these normally get adjusted when you use the change injector window
generally altered by the % of change in injectors size. you can just halve ttpmin and double ttpmax to begin with. these are just limits on the min/max time they are allowed to operate in
generally altered by the % of change in injectors size. you can just halve ttpmin and double ttpmax to begin with. these are just limits on the min/max time they are allowed to operate in