Page 1 of 1
Burn operation only available with Nistune Realtime board
Posted: Sat Feb 26, 2011 1:44 pm
by UNISA JECS
Hey Matt my 1994 B13 Nistune ECU is acting funny and im not even able to change anything or burn a change at
all, any suggestions?
Re: Burn operation only available with Nistune Realtime board
Posted: Sun Feb 27, 2011 11:21 am
by UNISA JECS
Is this a jumper setting problem on the ECU i.e. CJ1, CJ2? or a jumper setting on the Nistune board jumper setting problem J1,J2 or J3 or both?
I did notice that ECU Board jumper was set at CJ1 however it looked as though it was moved back and forth between the two setting previously (Chris @ DC Performance) I believe is the installer of the board.
Please advice thanks.
Current settings are:
ECU Board = CJ1 is jumped
Nistune Board = J2 and J3 are jumped
Nistune Board = J4 also jumped
Re: Burn operation only available with Nistune Realtime board
Posted: Sun Feb 27, 2011 1:38 pm
by UNISA JECS
Ok Matt I ended up moving the jumper from CJ1 to CJ2 and desoldered the J4 PGM connection which appeared at first glance to not be soldered together but it was stilled briged by a thin hair of solder and I unbridged that connection and everything seems to be working OK now it shows the REV 12 also and I was able to make a change and burn.
Re: Burn operation only available with Nistune Realtime board
Posted: Tue Mar 01, 2011 12:11 am
by Matt
Sorry for the delay. Yeah straight away I saw there was no 'REVID' so there was no nistune board