Nistune Forums

Hy

My 200sx S14 sometimes spits the error ( DTC Knock ... )

The engine does not knock !

Can I use these values ​​here in order to edit the knock sensor is inoperative ? Feedback Switch : Knock analysis IS OFF !

Thanks for your help!

Best regards

DTC is a fault code form the ECU. It does not mean the engine is knocking.

Perhaps there is a wiring issue to the ECU or a problem with the knock sensor itself. The code is raised when at anytime the knock sensor input goes out of range, so its a physical problem with the knock sensor

Disabling flags etc isn't going to fix a physical fault which is why the fault is raised. Refer to the factory service manual for checking this code

exactly it is probably a problem with the cable,
I can not values easily adjusted so that the knock sensor does not get a knock signal more?
I drive anyway no klopfmap

Read this:
http://nistune.com/docs/KnockGuideSR20.pdf