NIStune 0.941 now available

Matt · Post by **Matt** » Tue Mar 04, 2008 1:17 am

This has a fix for older Motes units broken by a recent change which requested serial number/vendor ID only available in later units

Also has Motec PLM wideband support added (tested with serial device simulator at this time)

dynotuner · Post by **dynotuner** » Tue Mar 04, 2008 3:33 pm

Woo hoo Matt! That must be why my dynapack motec wideband will not work with A/D converter.

Matt · Post by **Matt** » Tue Mar 04, 2008 10:12 pm

If you are using the 0 - 5 volt output then it should work through the A/D converter. If you use the serial output then you can connect NIStune straight into it

There is another update tonight 0.9142 to fix the problem with multiple cell updates broken since 0.920 release when maptracing was introduced. Only single cell updates were working

1SIKZ31 · Post by **1SIKZ31** » Sat Mar 15, 2008 1:13 am

Matt, where would one purchase a 0-5v A/D converter from?
Remember my AEM UEGO Wideband and how I couldnt connect to it?
Well.. I never did connect to it to this very day.

It does have the 0-5v output though, so if I could take the easy way out and get the AD converter to work with Nistune, that would be very cool. thanks

Matt · Post by **Matt** » Sat Mar 15, 2008 1:31 am

Did you try contacting AEM or going onto their forums for more support with their product? It would be worth a shot. You never got the output on the serial terminal.... so NIStune wouldnt be able to read anything in for displaying

The A/D converter link is listed on our website under wideband units. See the FAQ page