Page 1 of 1
NIStune 0.941 now available
Posted: Tue Mar 04, 2008 1:17 am
by Matt
This has a fix for older Motes units broken by a recent change which requested serial number/vendor ID only available in later units
Also has Motec PLM wideband support added (tested with serial device simulator at this time)
Posted: Tue Mar 04, 2008 3:33 pm
by dynotuner
Woo hoo Matt! That must be why my dynapack motec wideband will not work with A/D converter.
Posted: Tue Mar 04, 2008 10:12 pm
by Matt
If you are using the 0 - 5 volt output then it should work through the A/D converter. If you use the serial output then you can connect NIStune straight into it
There is another update tonight 0.9142 to fix the problem with multiple cell updates broken since 0.920 release when maptracing was introduced. Only single cell updates were working
Posted: Sat Mar 15, 2008 1:13 am
by 1SIKZ31
Matt, where would one purchase a 0-5v A/D converter from?
Remember my AEM UEGO Wideband and how I couldnt connect to it?
Well.. I never did connect to it to this very day.
It does have the 0-5v output though, so if I could take the easy way out and get the AD converter to work with Nistune, that would be very cool. thanks
Posted: Sat Mar 15, 2008 1:31 am
by Matt
Did you try contacting AEM or going onto their forums for more support with their product? It would be worth a shot. You never got the output on the serial terminal.... so NIStune wouldnt be able to read anything in for displaying
The A/D converter link is listed on our website under wideband units. See the FAQ page