Problem whem try to input the work into the car (solved)

bloodevil · Post by **bloodevil** » Sun Mar 15, 2009 10:43 pm

ok so this is my problem ..

I read ok.. whem i want to save my work in to the car it saves (doesnt do any erros) i shut down the pc remove the cable and whem i put the car back to work it is the same ..

It doenst save the work after i turn off the car , before i turn off the car it is ok .. but when i turn on the work is not there ..

ps: sorry my bad english hope you understand...

my car is a s14a board type4

cheers

MichaS14a · Post by **MichaS14a** » Sun Mar 15, 2009 11:05 pm

Did you click on "Burn changes permanently" before you close NIStune? In the picture below I have marked which button it is.

bloodevil · Post by **bloodevil** » Sun Mar 15, 2009 11:17 pm

MichaS14a wrote:Did you click on "Burn changes permanently" before you close NIStune? In the picture below I have marked which button it is.

i did not.. i gonna try it today .. feedback later

Cheers and thanks for your fast answer

bloodevil · Post by **bloodevil** » Sun Mar 15, 2009 11:31 pm

Man i feel a bit estupid ... but problem solved

Once again thks ..

MichaS14a · Post by **MichaS14a** » Mon Mar 16, 2009 12:13 am

No problem.